![]() Why are the shapes all angled relative to the base (housing? chassis?)? Because the cutter works by passing the die between rollers that press the fabric against the blades nestled down in that foam, and you get a much easier motion and a better cut if the blades pass through at an angle rather than straight on.īut what this means is that you need to be very aware of your grainline as you place your fabric on the die. ![]() You can put up to 6 layers of quilting fabric on a die, so you don't have to cut just one square at a time. Life is too short.Īs you can see, the dies from the Qube are square and cut one to four shapes, depending. It also includes a DVD, but i have not watched it. But there is always the chance that there could be a die I MUST have which only works in the Go, so I went with my normal philosophy of "better to have too much than not enough." But then again, that is also probably why I'm fat. So far, I haven't yet encountered a die I think I would use that wouldn't have been compatible with the Go Baby, so considering its lower price tag, its lighter weight, and its smaller footprint, the Baby might have been a better purchase. ![]() Except for the 12" Qube, all the dies from all the other Qubes are compatible with either the Go or the Go Baby. I chose this one not because I necessarily wanted 8" blocks, but because I tend to use these sizes (4.5" and 2.5" squares, 2.5" and 4.5" half square triangles, etc.) quite a lot. Accuquilt makes the Qube in four sizes (6", 8", 9", and 12"), all with the same shapes, just different sizes for each shape.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |